EZILIFT Gas Strut for BMW 3 SERIES E36 316i Compact 318ti 318i 318is 320i 323i Sedan 325i Coupe Convertible 328i

EZILIFT, a new player in the Australian market, is the answer when needing replacement gas struts. There is an EZILIFT to suit most cars, SUVs and 4x4s from a comprehensive range and fitment can be an easy “do it yourself” job.

EZILIFT gas struts are sold as single units but as most gas struts are fitted as pairs it is recommended that both gas struts are replaced together.

EZILIFT gas struts are manufactured by a large O.E. manufacturer whose products comply with the latest engineering standards that meet or exceed vehicle manufacturers standards. They feature a heavy gauge body which is baked painted for long lasting protection of the product appearance and finish. The rods are hardened and polished; they will prolong the life of the top seal and of the product itself.

All applications are catalogued but before removing the worn units check that the extended length and end fittings are the same

EZILIFT gas struts are covered by an Industry leading 3 YEAR warranty from date of purchase. It’s just all easy going…. with EZILIFT!

Installation:

Always replace both gas struts to ensure top performance and to prevent twisting caused by uneven loading.

EZILIFT gas struts typically store a gas charge of over 330 Newton and cannot be compressed by hand.

EZILIFT gas struts can be installed in minutes with no special tools required.

Careful inspection of all hinges and connecting points should be made for wear and tear or stress fractures. These should be replaced or repaired before gas strut installation.

INSTALLATION INSTRUCTIONS
1. Turn off ignition. If old gas strut has a window demister electrical connection, carefully disconnect the fittings.
2. Replacing worn gas struts it's recommended done with 2 people. 1 gas strut will not support the weight on its own.
3. Before removing old gas strut, examine any fittings supplied to determine which components must be re-used.
4. Have someone hold the hatch, bonnet, boot or rear window open while replacing the gas struts.
WARNING – DO NOT USE A PROP STICK
5. The new gas strut must be installed in the same position as the old one which was removed. Do not scratch the rod.
6. Do not remove both gas strut at the same time. Replace one, then close and open the hatch/boot/bonnet and then remove and replace the second gas strut.

EZILIFT gas strut to suit:

BMW 3 SERIES E36 318ti 4/96-12/99 suits Bonnet

BMW 3 SERIES E36 316i, 318i, 318is, 320i, 323i Sedan 4/91-8/98 suits Bonnet

BMW 3 SERIES E36 325i Sedan, Coupe 4/91-5/95 suits Bonnet

BMW 3 SERIES E36 325i Convertible 10/92-5/95 suits Bonnet

BMW 3 SERIES E36 328i Sedan, Coupe 6/95-6/99 suits Bonnet

BMW 3 SERIES E36 328i Convertible 6/95-9/00 suits Bonnet