Rubi Triller Tile Vibrator 18948

The electric thumping system is suitable for both interior and exterior work for:

Removing possible air voids that may have been created when laying tiles of size L, XL, XXL, and SLAB, in thicknesses from 3 to 100 mm, as they settle on the adhesive.
Replacing the mallet or float in the tamping process.
Reducing the breakage rate during the tiling process.
Preventing possible breakage during later handling, such as perforation or tamping, and loosening of the tiles in the future.

The vibrating must always be carried out from the centre of the tile to the outside, and always in the adhesive combing direction. For large SLAB type tiles, this vibration must always be carried out with delayed-tack adhesives.
Before vibrating, try to ensure that the adhesive is fully distributed over the entire surface area of the slab with no clumps, especially in the case of thin slabs or ones that have complicated cuts.
Application of materials for tile substrate, insulating materials and membranes or for spacing and materials for underfloor heating. These must be placed on the adhesive, pressed and then vibrated in the direction of the adhesive combing. The open processing time of the adhesive must be complied with.
Dry laying of concrete paving stones and slabs with polymeric sand, as the joint must be filled completely from the bottom to the surface. The vibrator easily vibrates the polymeric sand right down to the bottom, thus preventing air pockets in these joints. Furthermore, it also ensures that the polymer particles are well distributed throughout the depth of the joint.
Laying of concrete, paving, and natural stone tiles on wet cement. The vibrating provides good leveling even when the gaps are several millimeters.