Features:

• Slim Tool Body - tool head has been re designed to be slimmer than the previous model enabling the tool to have greater access to tight corners or confided spaces.
• One Touch Bit Installation - new bit installation has been designed to prevent the bit from unexpectedly falling off. A more effective mechanism has been designed increasing the strength of the chuck with out increasing the resistance required to install a bit.
• Enhanced Anvil Holder - material change from needle bearing to ball bearing provides reduction of bit wobbling. Providing more stability and control when fastening.
• Quick Change Selector - one touch mode selector located above the trigger allows the user to jump between modes single handed. Quickly changing between modes improves efficiency as you no longer have to take your hand off the tool.
• Light Mode - enables the tool to be used as a torch in dark environments. To turn the light on set the F/R change lever to the neutral position and pull the switch trigger. To turn off the light pull the trigger again.
• 4 Optimised Application Modes - 4 assist mode variations; T mode 1 and 2 for self-drilling screws in both thick and thin sheet metal. Wood mode for fastening long wood screws. Bolt mode with rotation auto stop for tightening / loosening bolts.
• 4 Speed Power Selection - 4 electronic speeds allow the user to adjust the power, speed and impact rate to suit the fastening application.

Makita 5.0Ah Lithium Battery with Charge Indicator BL1850B-L

Features:

• Star Protection
• Battery Fuel Gauge
• Multi-contact slide type terminal
• Protective gel coating
• Active 3 Controls current, voltage and thermal temperature
• Shock absorbing construction
• The fastest charge times in the industry
• Intelligent battery & charger communication system
• Protective gel coating - Sensitive electronics are protected with a thick gel coating, preventing damage against dust & moisture.
• Shock absorbing construction - Battery cells are protected in an internal bumper case with foam pads at the base to protect against shock.
• Multi-contact slide terminal - Ensures stable contact with the tool even under extreme vibration.
• Overload Protection - The battery and tool communicate, protecting your tool and battery from overload by cutting power when put under abnormally high current draw.
• Over-discharge Protection - Monitors battery charge capacity and cuts power to protect battery cells.
• Over heat protection - Extreme heat damages ALL batteries. If the battery reaches a certain level of heat it will cut power to the tool.
• Up 66% more run time than BL1830*
• 4-Stage battery fuel indicator
• 45 minute charge time

Makita Active 7.2-18V Li-Ion Rapid Charger DC18RC 195589-2

Features:

• Fast charging - charges Li-Ion 3.0Ah battery in only 22 minutes
• Built-in CPU - gathers information from the battery's memory chip to determine optimum charging method
• Forced air cooling fan - cools the battery to minimise charging time
• Digital power display identifies the condition of the battery and charging condition