Makita 18V Brushless 6.4mm Riveter DRV250Z

Features:

• Adjustable rivet diameters - the DRV250 is capable of pulling rivets up to 6.4 mm (1/4") including 6.0 mm (1/4"), 4.8 mm (3/16"), 4.0 mm (5/32"), 3.2 mm (1/8") and 2.4 mm (3/32")
• Rivet holding mechanism - mechanism in the nose piece holds the rivet in place even when working on flat surfaces, preventing the rivet from falling out. Increasing safety and convenience
• LED light - after engaging the switch trigger the LED joblight will illuminate and remain on for approximately 10 seconds after the switch is released
• Short center height - the height between the top of the tool housing and the centre of the nose cone is only 26 mm allows the user to position the head comfortably in tight and narrow places
• Transparent mandrel box - after installing the rivet, eject the broken off mandrel into the transparent mandrel box by tilting the tool backwards. The box catches each mandrel and the user can see once the container is full and needs to be emptied

Makita 18V Brushless 4-Stage Impact Driver DTD171Z

Features:

• Enhanced anvil holder - material change from needle bearing to ball bearing provides more stability when using longer bits
• Quick switch function - the quick switch button allows the user to rapidly switch between the 4 stage impact selection or 2 pre-set function modes
• Multi function control panel - control panel displays 4-stage impact selection as well as 4 mode functions. Assist mode, reverse rotation mode and Tek screw mode 1 and 2
• Brushless motor - powerful and compact the BL44 produces high power in a compact design ideal for rapid stop and start applications normally undertaken by impact drivers
• Left and right twin LED - twin LED job lights have been repositioned onto the left and right of the housing providing a brighter wider light. The LED light can also manually be turned on and off from the multifunction panel
• Variable speed trigger - as well as the multi speed control panel the user can optimise the speed of the impact driver via the trigger
• XPT - eXtreme Protection Technology - enhances dust and drip resistant performance for use in outdoor applications or harsh environments

Makita 5.0Ah Lithium Battery with Charge Indicator BL1850B-L

Features:

• Star Protection
• Battery Fuel Gauge
• Multi-contact slide type terminal
• Protective gel coating
• Active 3 Controls current, voltage and thermal temperature
• Shock absorbing construction
• The fastest charge times in the industry
• Intelligent battery & charger communication system
• Protective gel coating - Sensitive electronics are protected with a thick gel coating, preventing damage against dust & moisture.
• Shock absorbing construction - Battery cells are protected in an internal bumper case with foam pads at the base to protect against shock.
• Multi-contact slide terminal - Ensures stable contact with the tool even under extreme vibration.
• Overload Protection - The battery and tool communicate, protecting your tool and battery from overload by cutting power when put under abnormally high current draw.
• Over-discharge Protection - Monitors battery charge capacity and cuts power to protect battery cells.
• Over heat protection - Extreme heat damages ALL batteries. If the battery reaches a certain level of heat it will cut power to the tool.
• Up 66% more run time than BL1830*
• 4-Stage battery fuel indicator
• 45 minute charge time

Makita Active 7.2-18V Li-Ion Rapid Charger DC18RC 195589-2

Features:

• Fast charging - charges Li-Ion 3.0Ah battery in only 22 minutes
• Built-in CPU - gathers information from the battery's memory chip to determine optimum charging method
• Forced air cooling fan - cools the battery to minimise charging time
• Digital power display identifies the condition of the battery and charging condition